The 3 in 1 feeder is more and more widely used in stamping production because of its energy saving, land saving and easy operation. However, the traditional three-in-one feeder has a problem that manual feeding is required for manual feeding. Automated stamping production.
The traditional feeder has a feeding rack at the feeding inlet of the leveling feeder head, and a hydraulic loading trolley is arranged on the left side below the tray. In actual use, the rolled metal material is placed. On the hydraulic trolley, the loading trolley can be started to move to the main shaft of the three-in-one feeder, so that the coil is wound by the expansion and contraction roller, and then the material of the material is pulled by the material. The feeding frame enters the leveling feeding machine head, and then the three-in-one feeder is used to continuously punch the action, but once the material of the roll is used up, the work of repeated feeding is required; and for the thick steel plate (material) In the case of thicker than 4mm, it is very difficult to pull the material by human force. At the same time, if there is any carelessness during the application of force, it is easy to cause personal injury; in addition, the material of the coil is pulled to the feeders. At the entrance of the feeder, since it is pulled out from the cylindrical material roll, the material still has a certain curvature, that is, a form in which the concave arc is upwardly lifted, and it is hardly pulled to the horizontal inlet of the leveling feeder, still belonging to Not easy, especially the thicker the material, the smaller the volume of steel is more difficult There must be subjected to slightly beat fashion flat work, spend more time and resources into force, the labor intensity is great, while wasting a lot of effective work time, it was criticized by many customers.
In order to make the 3 in 1 truly realize the full automatic use and operation, Fanty machinery will change the feeding frame of the leveling feeding head to the material head bending and flattening device, and use the active displacement of the folding arm to roll the material. The material is clamped, and then pre-leveled by the hydraulic head screeding device. and the presser arm, the feeding arm and the stopper arm fully realize full automatic feeding, and the operator only needs to be in the console. The touch control on the touch screen can be operated, the feeding is fast and stable, and the efficient and safe feeding is fundamentally ensured.
