Material type of feeder 1. Sheet feeder: There are robot, sheet servo feeder, air sheet feeder, automatic take-up feeder. It is not necessary to use the coil material as the raw material, and it can be used for continuous stamping and blanking operations with single die, composite die and progressive die. The working efficiency is 2 to 10 times of manual and no one is negligent. The flake feeder developed by our company has strong versatility, wide application, suitable size and thickness. A feeder can be easily installed on any punching machine. It is very convenient to install and debug. It can be adapted to small batches and multiple specifications of automatic production, and can be adapted to medium and large batches of automated production.
2. Strip feeding machine: automatic feeding feeder, automatic feeding feeder, automatic feeding feeder, automatic feeding feeder. The strip feeder is tailored to the customer's machine and materials. The stack of materials is stacked on the rack, automatically transported by the robot, and automatically fed and stamped. If there is too much oil between the materials, the two pieces of material stick together and are handled by the customer. The manipulator is installed on both sides of the machine tool mold, and the mold opening distance needs to be greater than 300mm. Suitable for automatic material cutting and stretching of large board materials. The product needs to automatically fall under the mold.
3. Coil feeder: There are servo feeder, three-in-one feeder, air feeder, high-speed roller feeder, left and right swing feeder, servo yaw feeder, leveling feeder, left and right shift feeder. The coil feeder is suitable for continuous production of coil materials, and a type of feeder for continuous feeding, which can produce continuous coil feeders: air feeder, high speed roller feeder, servo feeder, swing feeder.
4. High-speed roller feeder: The roller feeder is the current feeding device. The principle is to connect the output shaft of the punching rod through the connecting rod, and the punching press drives the operation. The feed of the feeder is adjusted by adjusting the yaw amplitude of the eccentric disk. length. Advantages of high-speed roller feeder: high feeding accuracy, high speed, no additional energy supply, and extremely low failure rate. Disadvantages of high-speed roller feeder: Due to the limited eccentricity of the eccentric disk, the feeding length can only reach 300mm, and the feeding step adjustment is inconvenient. The punching machine needs the output shaft to be installed.
5. Air Feeder: The air feeder is a feeding device used in the stamping industry. The principle is to use the air source as the power, clamp the material through the cylinder, feed the cylinder by the telescopic stroke, and adjust the feed length through the cylinder. The length of the trip is controlled. Air feeder advantages: easy to operate, easy to install, affordable, and can achieve automatic stamping feeding equipment at a low price. In actual production, it is mainly used for feeding of stamping products with low precision and fast speed. Disadvantages of air feeder: easy to damage materials, O-ring wear has an impact on the feeding accuracy.
