What is the principle of the feeder? How does the feeder work, how to achieve a stable feeder for punch press production! Nowadays, the development of automation technology, the continuous improvement of the technical level of manufacturing, the improvement of manufacturing capacity, the traditional manufacturing industry has been eliminated by manual development, replaced by fully automated production, automatic feeding equipment for punching production came into being, many customers may still I don't know how the automatic feeding machine works for the feeder of the punching machine. I don't know the principle of the feeding machine.
Feeder
So what is the principle of the feeder and how can it be run? When the punch feeder is running, firstly, according to the material width of the stamping material, the appropriate distance between the two sliding seats can be adjusted by rotating the adjusting screw. Then, the punching material passes through the second linear drive of the feeding device to drive the upper feeding roller to move away from the lower feeding roller, enters the servo-driven upper and lower feeding rollers, and cooperates with the upper and lower leveling rollers to adjust the width to achieve material leveling. .
After the material enters the leveling machine and is leveled, it is input into the feeder. Similarly, the feeder adjusts the width of the material through the adjustable sides, and then passes through the eccentric wheel, which is driven by the servo-driven roller. It is stable and orderly, and the cycle time is the same according to the punching. The stamping material is fed to the punching processing area. After the stamping coil is fed into the upper and lower feeder rollers, the front and rear distances of the upper and lower feeder rollers are adjusted by the eccentric wheel. After the adjustment is completed, the servo drive motor runs to drive the connecting rod to rotate, and the connecting rod drives the transmission shaft to rotate back and forth. The transmission shaft drives the lower roller to rotate stepwise through the one-way transmission device, and the lower roller and the upper roller rotate synchronously, thereby sequentially conveying the raw material belt to advance.
Punch feeder
There are many kinds of feeder equipment, such as stamping robots, three-dimensional robots, etc. We are talking about punch presses for punching presses, or punching feeders, also called punch feeders, etc. Manual roller feeder, there is also a computer-controlled NC servo feeder and a three-in-one feeder that combines a roll holder, a leveler, a feeder, and three units, but no matter what the feeder is, its main The feeding method is the same, which is an auxiliary equipment for continuous production of stable and efficient stamping for punching machines.
