Every product has a lot of problems when it is used. Even if it is a product that everyone likes, it will be used in such a problem. For this aspect, we need to know how to improve the safety performance of our products. If you know the knowledge of this aspect, you can increase the life of the product and respond to various faults. For example, the three-in-one feeder that everyone loves. The three-in-one feeder is widely used in the industry and is recognized and adopted by the majority of users. Then the question has come. Have you ever understood the problem of overhauling the feeder mould? The problem of the feeder has been long since it is natural, then everyone wants to know how to repair the feeder mould? Today, the feeder manufacturer will teach you how to explain. Maintenance method of feeder mold:
1, spring factor
The three-in-one feeder spring breaks or the equal height sleeve is not equal, so that the stripping plate is tilted, or the spring is not prepared very often, causing overlapping punching and damaging parts.
2, waste blocking
The blanking hole of the three-in-one feeder is not drilled or the size does not match or falls on the bed and is not cleaned in time, and the punch and the lower die plate are damaged more.
3, buried in the heat
The quenching temperature is too high or different, the temperature of the tempering time is not appropriate, and the quenching time is not fixed; the problem occurs only after a period of use.
Feeder
4, set up errors
Misplaced parts are damaged in position and orientation.
5, improper stamping
The working height is adjusted too low, the guide column loses oil, the material is mis-delivered or washed, and the surrounding equipment such as feeding, discharging, receiving machine is damaged, the air tube is not installed or not opened, the punching is abnormal, etc., causing damage.
6, the punch drops
The end is fully fixed or suspended, or the screw is too fine to be strong, or the punch is broken.
7, stamping stack
The overlap of the sheets continues to be stamped, usually as the stripping plate breaks.
8, foreign matter enters
When the product is blown out, the mold part is collapsed and dropped, and the screw protrudes from the die surface or other objects into the mold, which may damage the lower mold, the stripping plate or the punch, and the guide post.
These eight aspects of the maintenance method must be familiar to everyone, and the next time you encounter such a problem, you can know how to deal with it. Today, the feeder manufacturer will tell you about it here, I hope that it will be of great help to everyone to understand the feeder!
