1, one-way bearing
It is embedded with super-hard alloy and matched with roller bearings. It has wear resistance, safety, high precision and long service life. The gear is overheated and H600 is precision ground and the transmission precision is high.
2, the roller
It adopts hollow type, light weight and small rotary inertia, which can be stopped immediately to ensure the feeding accuracy. After heat treatment, HR600 is hardened and hardened, and the hardness is high, the wear resistance is large, and the service life is long.
3, disc brakes (general brakes)
The advanced clutch is used to make the two sides of the film completely contact, with long life, good stability and high precision.
4, reverse device
(1) The structure is the same as that of the one-way device, and the lower wheel can be controlled quite
accurately. The long-term use will not cause the lower wheel to have the slightest backward phenomenon, and
the stability and precision are quite high.
(2) It is not caused by the oil splashing during the stamping, but the brake is out of order and the lower
wheel is reversed, and the distance is not accurate.
(3) It is not easy to generate high heat.
(4) With super hard alloy and roller, it is not easy to wear.
(5) The action mode is the circumference and movement of the roller, not the linear motion of the four guide
columns. So there will be no seizures
(6) The friction is small, the required transmission torque is relatively reduced, and the transmission
mechanism is less likely to be damaged.
(7) If there is a reverse setting, the speed can be 30/m minutes, generally 20 m/min, and the efficiency is
increased by 50%.
(8) Special structure increases the service life.
5, PU wheel
A stamping product suitable for a material having a higher surface does not cause any indentation or scratch on the surface of the material.
6, fine-tuning the distance adjustment device: (specially suitable for models above 1310NS)
The structure is the same as the eccentric disk, and the adjustment step is convenient. When the
adjustment eccentric disk is not too different from the target value, it is only necessary to adjust the fine
adjustment device to save time.
Note: For each model, the general brakes are standard.
If there is a reverse device, the general brake device is an auxiliary, double kill system.
