The operation flow of the three-in-one feeder is as follows:
1. Lifting the steel coil on the loading trolley, it is not necessary to make the steel coil in a stable state, otherwise the steel coil may fall off from the loading trolley.
2. Press the “feeding car” or “feeding back” button to stop the loading trolley from stopping at the bottom of the uncoiler.
3. Press the “Feed Up” button until the coil is topped to the proper position.
4. Press the “feeding car” or “feeding back” button to make the loading trolley accurately run to the middle of the reel, and press the “feeding car up” or “feeding down” button to adjust the height of the steel coil.
5. Press the “Reel tightening” button until the reel tightens the steel coil.
6. Press the “Feed down” button until the top of the loading trolley is lowered to the lowest position. You can also remove the trolley.
The precautions for the three-in-one feeder roll-up operation process are as follows:
During the winding process, it is forbidden to remove the trolley when the steel coil has not reached a sufficient height, and at the same time, it is forbidden to remove the loading trolley when the reel is not clamped. Otherwise, the loading trolley and the reel may be damaged, or steel may appear. Roll off accident.
