At present, press feeders are widely used in the market. The punch feeder is also a precision instrument. We use it in the production process, if it is not used properly, it does not pay attention to maintenance or the operator lacks knowledge of the equipment. It will cause frequent equipment failures, equipment abnormalities, machine alarms, etc., so we need to maintain the equipment during the production process, in addition to the abnormality of the equipment should know how to solve. The following punch feeding machine Xiaobian sorted out how to deal with the alarm of the punch feeder system, I hope to help everyone!
The punch feeder loosening device is not smooth. The way to deal with the alarm situation:
1. Check if there is a fixed guide pin in the stamping die, and carefully check if problems are found and eliminated in time.
2. Check if there is any displacement in the direction of the punch feeder, and then check whether the direction of the punch is correct or not.
3. If the punch feeder is eccentric and the loose shaft loses oil, use kerosene and add butter.
Punching machine feeding machine irregular error occurs alarm handling measures:
1. Check whether the pressure plate is evenly stressed. If it is uneven, adjust the pressure of the relaxation device.
2. Whether the feeding mechanism used is pneumatically relaxed, then check if the air compressor pressure is normal.
3. Check whether the coil fed by the material rack is on the same level as the feeder and the mold.
The feeding mechanism of the feeder feeding position deviation causes the alarm phenomenon to be handled:
1. Check if the mold is at a 90° vertical angle with the feeder mounting plate;
2. Check if the material is square when entering the feeder;
3. Recalibrate the feed roller;
4. Using the relaxation device, the relaxation assisting guide is performed when the mold positioning needle enters one third of the material hole position.
Punch feeder conveyor transmission instability alarm situation:
1. Check if there is displacement in the installation position of the stamping die.
2. Check whether the air pressure reaches 0.45kgf/cm3 under the condition that the feeder continuously presses normally;
3. Whether the feeding time of the feeder is correct;
4, check whether the motor is normal (basic can rule out such cases)
The above is the alarm situation of the feeder when we often encounter punch press production. In special cases, you need to check the characteristics and find the alarm source to clear the alarm. If you cannot find the cause to solve the problem during the use of the equipment, you can contact the manufacturer of the punch feeder at any time.
